CLI Guide

Switch Management Commands 2132
• vrf-name—The name of the VRF associated with the routing table
context used by the command. If no vrf is specified, the global routing
table context is used.
Default Configuration
ARP packet tracing is disabled by default.
Command Mode
Privileged Exec mode.
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
Only IPv4 addresses are supported with the vrf parameter.
This vrf parameter is only available on the N3000-ON/N3100 switches.
Debug output should be enabled with caution. Switch behavior may be
adversely affected by the additional processing load incurred from enabling
debug.
Example
console#debug arp
debug authentication interface
Use this command to enable Authentication Manager debug traces for the
interface.Use the no form of this command to set the debug trace to factory
default value.
Syntax
debug authentication {event | all} interface-id
no debug authentication {event | all} interface-id
• event—Traces Authentication Manager debug events.
• all—Enables all Authentication Manager debugs.
• interface-id—The interface to trace.