CLI Guide

Switch Management Commands 2278
Command Mode
Privileged Exec mode.
User Guidelines
This command forcibly logs out and disconnects a Telnet, SSH, HTTP or
HTTPs session. Use the show sessions command to display the session
identifier.
The session identifier ranges from 0-42. The all parameter disconnects all
telnet, SSH, HTTP or HTTPs sessions.
It is not possible to disconnect the EIA-232 (serial console) session.
exit
Use this command to disconnect the serial connection to a remote unit.
Syntax
exit
Default Configuration
There is no default configuration for this command.
Command Modes
User Exec mode on stack master.
Unit prompt on the stack member.
User Guidelines
This command is available in User Exec mode on the master unit serial port
and from the Unit prompt on member unit serial ports. The user need not be
currently connected over the serial port to connect to another unit.
The stack member being connected to must be up and running and
connected as part of the stack.
Example
Example 1: