CLI Guide

Switch Management Commands 2294
Example-Stack Port Errors
The following example shows stack port errors detected by the command.
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n)
Warning! Stack port errors detected on the following interfaces:
Interface Error Count
---------------- ----------------
Gi1/0/1 12
Gi1/0/3 22
Stack port errors may indicate a non-redundant stack topology exists. Fail-
over on a non-redundant topology may cause the stack to split!
Are you sure you want to reload the stack? (y/n)
service unsupported-transceiver
Use this command to avoid the following on using an unsupported optic.
• Logging of a message.
• Generation of SNMP trap.
Use the no form of this command to set the transceiver support to the factory
default.
Syntax
service unsupported-transceiver
no service unsupported-transceiver
Default Configuration
The default configuration is to log a message along with the SNMP trap
generation on insertion or removal of an optic that is not qualified by Dell.
Command Mode
Global Configuration mode