CLI Guide

Switch Management Commands 2303
Serial Number..................... ANF0L5J
Dell EMC Qualified................ Yes
The following example shows the optic parameters, but not the IDPROM
content as the entered activation code in incorrect.
console#show idprom interface tengigabitethernet 1/0/9 debug abc
Type.............................. SFP+
Media............................. 10GBASE-LRM
Serial Number..................... ANF0L5J
Dell EMC Qualified................ Yes
show interfaces
Use the show interfaces command to display the traffic statistics for one or
multiple interfaces. If no parameter is given, all interfaces are shown.
Syntax
show interfaces interface-id
• interface-id—The ID for any valid Ethernet interface (that is, a 1G,
10G, or 40G interface in standard interface format or a port-channel
identifier).
Default Configuration
This command has no default configuration.
Command Modes
All modes
User Guidelines
The show interface command shows the actual operational status of the
interface, which is not necessarily the same as the configuration.
Input/output rate statistics are collected every 10 seconds.
The RX and TX utilization (sum of the individual active links) is shown for
port-channels. The utilization is measured in kilobits per second.