CLI Guide

• OK
• Degraded
• Fault
• N/A
• Unknown
Reason
If Health is not OK, this field shows the reason for the health state.
Action
If Health is not OK, this field shows recommended actions to take to resolve the health issue.
Topo (C)
FC and SAS only. Configured topology.
Lanes Expected
SAS only. If the detail parameter is specified, this field shows the expected number of PHY lanes in the
SAS port.
Active Lanes
SAS only. If the detail parameter is specified, this field shows the number of active lanes in the SAS port. If
the port is connected and fewer lanes are active than are expected, the port status will change to Warning,
the health will change to Degraded, and event 354 will be logged.
Disabled Lanes
SAS only. If the detail parameter is specified, this field shows the number of disabled lanes in the SAS port.
PID
FC only. If the detail parameter is specified, this field is shown. If the port is using loop topology and the
port status is Up, this field shows the primary loop ID. If the port is not using loop topology or the port status
is not Up, this field shows N/A.
IP Version
iSCSI only. IPv4 or IPv6.
IP Address
iSCSI only. Assigned port IP address.
Gateway
iSCSI only. For IPv4, gateway IP address for assigned IP address.
Netmask
iSCSI only. For IPv4, subnet mask for assigned IP address.
Default Router
iSCSI only. For IPv6, default router for assigned IP address.
Link-Local Address
iSCSI only. For IPv6, the link-local address that is automatically generated from the MAC address and
assigned to the port.
MAC
iSCSI only. Unique Media Access Control (MAC) hardware address, also called the physical address.
SFP Status
If the detail parameter is specified, this field shows the SFP status:
• OK
• Not present: No SFP is inserted in this port.
• Not compatible: The SFP in this port is not qualified for use in this system. When this condition is
detected, event 464 is logged.
220
Alphabetical list of commands