CLI Guide

Examples From controller A, restart the Storage Controller in controller B.
# restart sc b
Restart both Storage Controllers.
# restart sc both
See also
restart mc
shutdown
restore defaults
Description Restores the default configuration on the controllers.
CAUTION: This command is for use only with the direction from a service technician.
For details about which settings are restored, see Settings changed by restore defaults on page 437.
NOTE: This command restores the default settings to the controllers and restarts each controller
module. Changes to host interface settings may cause loss of data availability and require some
reconfiguration to restore host access to volumes. Changes to network-port IP addresses may
cause loss of access to management interfaces.
Minimum role manage
Syntax
restore defaults
[noprompt]
[prompt yes|no]
Parameters
[noprompt]
Optional. Suppresses confirmation prompts. Specifying this parameter enables the command to
proceed without user interaction.
[prompt yes|no]
● yes: Allow the command to proceed.
● no: Cancel the command.
If this parameter is omitted, you must manually reply to prompts.
Examples Restore the default configuration on the controllers.
# restore defaults
See also
reset smis-configuration
restart mc
restart sc
resume replication-set
Description
Resumes the replication operations for the specified replication set. This command applies to virtual
storage only. You can run this command on the primary system.
When a replication set is suspended, all replications in progress are paused and no new replications
are allowed to start. When you run this command to resume replications, all paused replications are
resumed and new replications are allowed to occur. If you aborted a replication while the replication
set was suspended, the aborted replication does not resume.
Minimum role manage
Syntax
resume replication-set
104 Alphabetical list of commands