CLI Guide

set cloud-iq
Description Enables or disables the ability to use the Dell EMC CloudIQ application on a remote device to monitor,
analyze, and troubleshoot the storage environment.
Storage-system configuration data is sent hourly and performance data is sent every 15 minutes.
CloudIQ cannot be used until the SupportAssist agreement is accepted and SupportAssist is enabled.
When the agreement is accepted and SupportAssist is first enabled, CloudIQ is automatically enabled.
Thereafter, SupportAssist and CloudIQ can be disabled or enabled independently.
Minimum role standard
Syntax
set cloud-iq
[enabled|disabled|on|off]
Parameters
enabled|disabled|on|off
At least one parameter must be specified.
● enabled or on: Enables use of the CloudIQ application.
● disabled or off: Disables use of the CloudIQ application. This is the default.
Examples Disable use of CloudIQ.
# set cloud-iq disabled
See also
show cloud-iq on page 173
set support-assist on page 152
set controller-date
Description
Sets the date and time parameters for the system. You can set the date and time manually or
configure the system to communicate with a Network Time Protocol (NTP) server. Alternatively, you
can configure NTP by using the set ntp-parameters command.
NOTE:
● If you specify valid NTP parameters and manual date/time parameters in the same command,
the NTP parameters will take precedence. If the NTP server cannot be contacted, the date
and time will not be changed and no error message will be displayed. If you specify the
timestamp parameter and other manual date/time parameters in the same command, the
timestamp parameter will take precedence.
● If you change the time zone of the secondary system in a replication set whose primary
and secondary systems are in different time zones, you must restart the system to enable
management interfaces to show proper time values for replication operations.
Minimum role manage
Syntax
To set the date and time manually:
set controller-date
jan|feb|mar|apr|may|jun|jul|aug|sep|oct|nov|dec
day
hh:mm:ss
year
To set the date and time manually by specifying a timestamp:
set controller-dat
timestamp timestamp
116 Alphabetical list of commands