CLI Guide

Optional. Enables or disables File Transfer Protocol (FTP), a secondary interface for installing
firmware updates, installing security certificates and keys and downloading logs. This is disabled by
default.
[http enabled|disabled|on|off]
Optional. Enables or disables the standard PowerVault Manager web server. This is disabled by
default.
[https enabled|disabled|on|off]
Optional. Enables or disables the secure PowerVault Manager web server. This is enabled by default.
[management-mode v2|v3|linear|virtual]
Optional. Sets the default management mode for the system.
● v2 or linear: Uses linear-storage terminology in command output and system messages. For
example, vdisk for disk groups and pools.
● v3 or virtual: Uses terminology in command output and system messages that is generalized
for managing virtual and linear storage. For example, disk group for disk groups and pool for pools.
This is the default.
To change the management mode for the current CLI session only, use the set cli-parameters
on page 114 command.
[ses enabled|disabled|on|off]
Optional. Enables or disables the in-band SCSI Enclosure Services (SES) management interface. This
is disabled by default.
[sftp enabled|disabled|on|off]
Optional. Enables or disables SSH File Transfer Protocol (SFTP), a secure secondary interface for
installing firmware updates, installing security certificates and keys and downloading logs. All data
sent between the client and server will be encrypted. This is enabled by default.
To set the port numbers to use for SFTP and SSH, set the sftp-port and ssh-port parameters,
respectively. The port numbers must differ
[sftp-port port]
Optional. Specifies the port number to use for SFTP. The default is 1022.
[slp enabled|disabled|on|off]
Optional. Enables or disables the Service Location Protocol (SLP) interface. SLP is a discovery
protocol that enables computers and other devices to find services in a LAN without prior
configuration. This system uses SLP v2. This is enabled by default.
SMI-S uses SLP to advertise WBEM interfaces. If SMI-S is enabled, disabling SLP will prevent WBEM
interfaces from being advertised.
[smis enabled|disabled|on|off]
Optional. Enables or disables the secure Storage Management Initiative Specification interface (SMI-
S) interface. This option allows SMI-S clients to communicate with each embedded SMI-S provider of
the controller via HTTPS port 5989. HTTPS port 5989 and HTTP port 5988 cannot be enabled at the
same time, so enabling this option will disable port 5988. This is disabled by default.
SMI-S uses SLP to advertise WBEM interfaces. To use SMI-S and advertise WBEM interfaces you
must enable the smis parameter and the slp parameter.
[snmp enabled|disabled|on|off]
Optional. Enables or disables the Simple Network Management Protocol interface. Disabling this
option disables all SNMP requests to the MIB and disables SNMP traps. To configure SNMP traps
use the set snmp-parameters command. This is disabled by default.
[ssh enabled|disabled|on|off]
Optional. Enables or disables the secure shell CLI. This is enabled by default.
[ssh-port port]
Optional. Specifies the port number to use for SSH. The default is 22.
Alphabetical list of commands
145