CLI Guide

● celsius or c: Temperatures are shown in degrees Celsius. This is the default.
Management Mode
The management mode used in the current CLI session.
● Linear: Uses linear-storage terminology in command output and system messages. For example,
vdiskfor disk groups and pools.
● Virtual: Uses terminology in command output and system messages that is generalized for
managing virtual and linear storage. For example, disk group for disk groups and pool for pools.
To see the default management mode, use the show protocols command.
Examples Show current CLI settings.
# show cli-parameters
Basetypes
cli-parameters
status
See also
set cli-parameters
show protocols
show cloud-iq
Description Shows the CloudIQ setting.
Minimum role monitor
Syntax
show cloud-iq
Parameters
Shows whether the ability to remotely monitor the system by using the Dell EMC CloudIQ application
is enabled or disabled.
● Enabled – Use of the CloudIQ application is enabled.
● Disabled – Use of the CloudIQ application is disabled.
Specifies the status and date/time of the last transmission of storage system configuration data to
the support server.
CloudIQ Last Config Send Status
CloudIQ Last Config Send Time
Specifies the status and date/time of the last transmission of storage system performance data to the
support server.
CloudIQ Last Perf Send Status
CloudIQ Last Perf Send Time
Examples Show the CloudIQ setting.
# show cloud-iq
See also
set cloud-iq on page 116
show configuration
Description
Shows system configuration information.
NOTE: Output for this command is lengthy. To control whether the output halts after each
full screen to wait for keyboard input, enable or disable the pager parameter of the set cli-
parameters command.
Alphabetical list of commands 173