CLI Guide

The date and time, in the format year-month-day hour:minutes:seconds, when these
statistics were last reset, either by a user or by a controller restart.
Examples Show live performance statistics for all host ports.
# show host-port-statistics
Show live performance statistics for host port A1.
# show host-port-statistics ports a1
Basetypes
host-port-statistics
status
See also
reset all-statistics
show host-port-statistics
show host-phy-statistics
show ports
show initiators
Description
Shows information about initiators. The command will show information about all initiators by default,
or you can use parameters to filter the output.
Initiator entries are automatically created for host initiators that have sent an inquiry command or
a report luns command to the system. This typically happens when the physical host containing
an initiator boots up or scans for devices. When the command is received, the system saves the host
port information. However, the information is retained after a restart only if you have set a name for
the initiator.
Minimum role monitor
Syntax
show initiators
[hosts hosts]
[initiators]
Parameters
hosts hosts
Optional. A comma-separated list of the names of hosts containing initiators for which to show
information. If this parameter is omitted, information is shown for all initiators.
initiators
Optional. A comma-separated list of the names of initiators for which to show information. If this
parameter is omitted, information is shown for all initiators.
Output
Nickname
The name of the initiator.
Discovered
● Yes: The initiator was discovered and its entry was automatically created.
● No: The initiator was manually created.
Mapped
Shows whether the initiator is explicitly mapped to any volumes:
● Yes: At least one volume is explicitly mapped to the initiator.
● No: No volumes are explicitly mapped to the initiator.
Profile
Standard: Default profile.
210 Alphabetical list of commands