CLI Guide

Host Type
The host-interface type: FC; iSCSI; SAS.
ID
For an FC initiator, its WWPN. For a SAS initiator, its WWPN. For an iSCSI initiator, its node name
(typically the IQN).
Examples Show information about all initiators.
# show initiators
Show information about initiators in host Host1 only.
# show initiators hosts Host1
Basetypes
status
initiator
See also
delete initiator-nickname
set initiator
show host-groups (with the hosts parameter)
show inquiry
Description
Shows inquiry data for each controller module.
Minimum role monitor
Syntax show inquiry
Output
● Product vendor name, product ID, vendor ID, and SCSI product ID
● Management Controller firmware version and loader version
● Storage Controller firmware version and loader version
● Controller module serial number
● Media Access Control (MAC) address
● Network port
Examples Show inquiry data for controller modules in the system.
# show inquiry
Basetypes
inquiry
status
See also
show versions
show ipv6-addresses
Description
Shows static IPv6 addresses assigned to each controller's network port.
Minimum role monitor
Syntax
show ipv6-addresses
[controller a|b|both]
Parameters
controller a|b|both
Optional. Specifies whether to show addresses for controller A, controller B, or both. If this
parameter is omitted, information is shown for both controllers.
Alphabetical list of commands 211