CLI Guide

Output
Ctlr
The controller ID: A or B.
Index
The controller's index value for the address. The index is automatically assigned when adding a static
IPv6 address.
Label
The name assigned to the address, or ‘-’ if the address is unnamed.
Address
The IPv6 address with prefix length.
Examples Show static IPv6 addresses assigned to controller A.
# show ipv6-addresses controller a
Base types
ipv6-network-parameters
status
See also
add ipv6-address
remove ipv6-address
set ipv6-network-parameters
show ipv6-network-parameters
show ipv6-network-parameters
Description
Shows the IPv6 settings and health of each controller module's network port.
Minimum role monitor
Syntax
show ipv6-network-parameters
Output
Autoconfig
● enabled: Uses an IPv6 address computed by SLAAC or assigned by a DHCPv6 server,
depending on the network configuration. If a DHCPv6 address is available, then that address
is used. Otherwise SLAAC is used.
● disabled: Uses static IPv6 addresses set with the add ipv6-address command.
Gateway
The network port gateway IPv6 address.
Link-Local Address
The link-local IPv6 address.
Autoconfig IP
The automatically configured IPv6 address.
IPv6 Address (1-4)
Shown if Autoconfig is disabled. Shows between one and four manually set IPv6 addresses.
IPv6 Label (1-4)
Shown if Autoconfig is disabled. Shows the user-defined name, if set, for each manual IPv6 address.
Examples Show IPv6 network parameters for each controller module.
# show ipv6-network-parameters
Basetypes
ipv6-network-parameters
212 Alphabetical list of commands