CLI Guide

delete peer-connection
query peer-connection
set peer-connection
show pools
Description Shows information about linear and virtual pools. The command will show information for all pools
by default, or you can use parameters to filter the output. The system can have a maximum of two
virtual pools. The system can have a maximum of two virtual pools.
NOTE: For a virtual pool, new data will not be written to, or existing data migrated to, a degraded
disk group unless it is the only disk group having sufficient available space for the data.
Minimum role monitor
Syntax
show pools
[type linear|virtual]
[pool]
type linear|virtual
Optional. Specifies whether to show information for linear pools or for virtual pools. If this parameter
is omitted, information will be shown for both types.
pool
Optional. The name or serial number of the pool for which to show information. If this parameter is
omitted, information is shown for all pools
Output
Name
The name of the pool.
Serial Number
The serial number of the pool.
Class
● Linear: Linear pool.
● Virtual: Virtual pool.
Total Size
The total capacity of the pool.
Avail
The available capacity in the pool.
Snap Size
The pool capacity used by linear snap pools or virtual snapshots
OverCommit
● Enabled: The allocated size of the volumes can exceed the physical capacity of the pool.
● Disabled: The allocated size of the volumes cannot exceed the physical capacity of the pool.
Disk Groups
The number of disk groups in the pool.
Volumes
The number of volumes in the pool.
Low Thresh
The low threshold for page allocation as a percentage of pool capacity. When this threshold is
exceeded, event 462 will be logged with Informational severity.
Alphabetical list of commands
219