CLI Guide

FC only. If the detail parameter is specified, this field shows the link speeds that the SFP supports.
10G Compliance
iSCSI only. If the detail parameter is specified, this field shows the SFP's 10G compliance code. If
the SFP returns an unsupported code, this field will show the equivalent hex value.
Ethernet Compliance
iSCSI only. If the detail parameter is specified, this field shows the SFP's Ethernet compliance
code. If the SFP returns an unsupported code, this field will show the equivalent hex value.
Cable Technology
iSCSI only. If the detail parameter is specified, this field shows whether the SFP supports active or
passive cable technology.
Cable Length
iSCSI only. If the detail parameter is specified, this field shows the link length (in meters) that is
supported by the SFP while operating in compliance with applicable standards for the cable type.
Examples Show information about host ports in each controller module.
# show ports
Show detailed information about host ports in each controller module.
# show ports detail
Basetypes
port
status
See also set host-parameters
show power-supplies
Description
Shows information about each power supply in the storage system.
Minimum role monitor
Syntax show power-supplies
Output
Encl
The ID of the enclosure that contains the power supply.
Id
The power supply position, shown as an index value that starts at 0 and increments from left to right
as viewed from the back of the enclosure
Serial Number
The serial number of the power supply.
Part Number
● (blank): Not applicable.
Name
The power supply identifier and location.
Firmware Version
● (blank): Not applicable.
● The firmware revision of the power supply.
Health
● OK
● Degraded
Alphabetical list of commands 227