CLI Guide

Success: Command completed successfully. (data_1) - Trust operation
completed successfully for this disk group. (2013-09-17 09:07:31)
Abort an unsafe trust operation when you decide not to risk using bad disks.
# trust enable
Success: Command completed successfully. - Trust is enabled.
(2013-09-17 09:05:37)
Location Serial Number Type State Partially Reconstructed Out Of
Sync Age
1.2 SN SAS LEFTOVR False True 6
1.4 SN SAS VIRTUAL POOL False False 7
1.5 SN SAS LEFTOVR True False 4
WARNING: Found partially reconstructed and out-of-sync disk(s). Using
these disks for trust will in most cases cause data corruption.
Because of the risk of data corruption, it is recommended that you
continue the trust operation only with the supervision of Support
personnel. If you are ready to continue, enter "continue" at the
prompt or enter "abort" to abort the operation and leave the disk
group offline.
> continue
If you continue with the trust operation, you risk corrupting data in
this disk group. Enter "accept" at the prompt if you intend to accept
this risk and proceed with the trust operation or enter "abort" to
abort the operation and leave the disk group offline.
> abort
Error: Command was aborted by user. (2013-09-17 09:05:49)
After enabling trust, disable it if you decide not to run trust disk-group.
# trust disable
Success: Command completed successfully. - Trust is disabled.
(2013-09-17 17:40:01)
See also
show disk-groups
show vdisks
verify disk-groups
verify vdisk
unfail controller
Description
Allows the partner controller module to recover from a simulated failure performed with the fail
command (which requires the manage role). If you attempt to unfail a controller that is operating, the
command will have no effect.
Minimum role manage
Syntax
unfail controller
Examples From controller A, unfail the partner controller.
# unfail controller
See also
fail
show controllers
Alphabetical list of commands 279