CLI Guide

host-group
Parameters
hosts hosts
A comma-separated list of the names of hosts to add to the specified host group. A name that
includes a space must be enclosed in double quotes.
Examples Add existing hosts Host3 and Host4 to existing host group HostGroup1.
# add host-group-members hosts Host3,Host4 HostGroup1
See also
remove host-group-members
show host-groups
show initiators
add host-members
Description Adds initiators to a host. A host can contain a maximum of 128 initiators.
To add an initiator to a host, the initiator must be mapped with the same access, port, and LUN
settings to the same volumes or volume groups as every other initiator in the host.
Minimum role manage
Syntax
add host-group-members
initiators initiators
host-name
Parameters
initiatorsinitiators
A comma-separated list of the nicknames or IDs of initiators to add to the specified host. A name that
includes a space must be enclosed in double quotes.
Examples Add existing initiators Init3and Init4 to existing host Host1.
# add host-members initiators Init3,Init4 Host1
See also
create host
remove host-group-members
show host-groups
show initiators
add ipv6-address
Description
Adds a static IPv6 address for a controller network port. A maximum of eight static IPv6 addresses
can be configured, four per controller. These addresses can be configured at any time, but can
only become active when the set ipv6-network-parameters command's autoconfig parameter is
disabled.
All addresses added to the IPv6 address list should be reachable if autoconfig is disabled. They are
ignored if autoconfig is enabled.
Static addresses are stored on the controller enclosure midplane. Therefore the addresses will persist
even if both controller modules are replaced.
Minimum role manage
Syntax
add ipv6-address
[address-label name]
34 Alphabetical list of commands