CLI Guide

Table 74. network-parameters properties
Name Type Description
durable-id string Controller network port ID in the format mgmtport_controller-ID
active-version uint32 The configured network port IP version.
● 4: IPv4
● 6: IPv6
ip-address string Controller network port IP address.
gateway string Controller network port gateway IP address
subnet-mask string Controller network port IP subnet mask
mac-address string Controller network port MAC address.
addressing-mode string
● Manual: Network settings are set manually (statically).
● DHCP: DHCP is used to set network parameters.
addressing-mode-numeric uint32 Numeric equivalents for addressing-mode values.
● 1: Manual
● 2: DHCP
link-speed string
● Unknown: For a system operating in Single Controller mode, this controller
module is not present.
● 10mbps: The network port link speed is set to 10 Mb/s.
● 100mbps: The network port link speed is set to 100 Mb/s.
● 1000mbps: The network port link speed is set to 1000 Mb/s.
link-speed-numeric uint32 Numeric equivalents for link-speed values.
● 0: 10mbps
● 1: 100mbps
● 2: 1000mbps
duplex-mode string
● Undefined: For a system operating in Single Controller mode, this controller
module is not present.
● Half: The network port duplex mode is set to half duplex.
● Full: The network port duplex mode is set to full duplex.
duplex-mode-numeric uint32 Numeric equivalents for duplex-mode values.
● 0: full
● 1: half
● 2: Undefined
health string The health of the network connection.
● OK
● Degraded
● Fault
● N/A
● Unknown
health-numeric uint32 Numeric equivalents for health values.
● 0: OK
● 1: Degraded
● 2: Fault
● 3: Unknown
● 4: N/A
health-reason string If Health is not OK, the reason for the health state.
health-recommendation string If Health is not OK, the recommended actions to take to resolve the health issue.
366 API basetype properties