CLI Guide

Table 101. sas-status-controller-a properties (continued)
Name Type Description
● Expander-Ingress-1 : Expansion port 1 ingress PHY.
● Ingress : Expansion port ingress PHY.
● Inter-Exp : Inter-expander PHY.
● SC : Storage Controller PHY.
● SC-0 : Storage Controller primary PHY.
● SC-1 : Storage Controller alternate PHY.
● SC-A : Storage Controller alternate PHY.
● SC-P : Storage Controller primary PHY.
● SCA- A : Storage Controller A alternate PHY.
● SCA-P : Storage Controller A primary PHY.
● SCB-A : Storage Controller B alternate PHY.
● SCB-P : Storage Controller B primary PHY.
status string PHY status.
● Unavailable : No status information is available.
● Enabled - Healthy : The PHY is enabled and healthy
● Enabled - Degraded : The PHY is enabled but degraded.
● Disabled : The PHY has been disabled by a user or by the system.
status-numeric uint32 Numeric equivalents for status values.
● 0: Unavailable
● 1: Enabled - Healthy
● 2: Enabled - Degraded
● 3: Disabled
elem-status string The SES status that corresponds to the PHY status.
● Disabled : Critical condition is detected.
● Error : Unrecoverable condition is detected. Appears only if there is a
firmware problem related to PHY definition data.
● OK : Element is installed and no error conditions are known.
● Non-critical : Non-critical condition is detected.
● Not Used : Element is not installed in enclosure.
● Unknown : Either:
○ Sensor has failed or element status is not available. Appears only if an
I/O module indicates it has fewer PHYs than the reporting I/O module, in
which case all additional PHYs are reported as unknown.
○ Element is installed with no known errors, but the element has not been
turned on or set into operation.
○ SES status cannot be determined for another reason.
elem-status-numeric uint32 Numeric equivalents for elem-status values.
● 0: Error
● 1: OK
● 2: Disabled
● 3: Non-critical
● 4: Error
● 5: Not Used
● 6: Unknown
● 7: Unknown
● 8: Unknown
elem-disabled string
● Enabled : PHY is enabled.
● Disabled : PHY is disabled.
elem-disabled-numeric uint32 Numeric equivalents for elem-disabled values.
API basetype properties 389