CLI Guide

Table 103. security-communications-protocols properties (continued)
Name Type Description
● 1: Enabled
debug-interface string
● Disabled : The Telnet debug port is disabled.
● Enabled : The Telnet debug port is enabled.
debug-interface-numeric uint32 Numeric equivalents for debug-interface values.
● 0: Disabled
● 1: Enabled
inband-ses string
● Disabled : The in-band SES interface is disabled.
● Enabled : The in-band SES interface is enabled.
inband-ses-numeric uint32 Numeric equivalents for inband-ses values.
● 0: Disabled
● 1: Enabled
activity-progress string
● Enabled : Access to the activity progress interface via HTTP port 8081
is enabled. This mechanism reports whether a firmware update or partner
firmware update operation is active and shows the progress through each
step of the operation. In addition, when the update operation completes,
status is presented indicating either the successful completion, or an error
indication if the operation failed.
● Disabled : Access to the activity progress interface via HTTP port 8081 is
disabled.
management-mode string The default management mode.
● Linear : Uses linear-storage terminology in command output and system
messages. For example, vdisk for disk groups and pools.
● Virtual : Uses terminology in command output and system messages that
is generalized for managing virtual and linear storage. For example, disk
group for disk groups and pool for pools.
management-mode-numeric uint32 Numeric equivalents for management-mode values.
● 2: Linear
● 3: Virtual
activity-progress-numeric uint32 Numeric equivalents for activity-progress values.
● 0: Disabled
● 1: Enabled
sensors
This basetype is used by show sensor-status on page 239.
Table 104. sensors properties
Name Type Description
durable-id string Sensor ID.
enclosure-id uint32 Enclosure ID.
drawer-id
(5U84 enclosure)
uint8
● 0 : Top
● 1 : Bottom
drawer-id
(2U12/24 enclosure)
uint8 Not applicable ( 255 ).
controller-id string
● A : Controller A.
API basetype properties 393