CLI Guide

Table Of Contents

NOTE: If a rescan is in progress, the clear operation will fail with an error message saying that an

EMP does exist. Wait for the rescan to complete and then retry the clear operation.

Minimum role manage

Syntax

clear expander-status

[enclosure ID]

Parameters [enclosure ID]

Optional. The enclosure number. If this parameter is omitted, the command clears the counters and

status of all enclosures.

Examples Clear the expander status for the enclosure with ID 1.

# clear expander-status enclosure 1

See also show expander-status

clear fde-keys

Description

Clears the lock key ID and import lock ID used with Full Disk Encryption.

Use this command to temporarily deny access to data on the disks during a period when the system

will not be under your physical control. If the lock keys are cleared while the system is secured, the

system enters the Secured, Lock Ready state, in preparation for the system being powered off

and transported. No further FDE configuration is allowed until the system has been power that is

cycled. Disks remain in the Secured, Unlocked state until they are power that is cycled.

After the system has been transported and powered on, the system and disks will enter the

Secured, Locked state; and volumes will become inaccessible. To restore access to data, re-enter

the original passphrase by using the set fde-lock-key command.

Minimum role manage

Syntax

clear fde-keys

[current-passphrase value]

Parameters

[current-passphrase value]

Optional. If the system is secured, you can provide the current passphrase as part of the command. If

this parameter is omitted, the command prompts you for the current passphrase.

Examples Clear the lock keys in preparation for shipping a system to a new location.

# clear fde-keys current-passphrase myPassphrase