CLI Guide

Table 146. Settings changed by restore defaults (continued)
Setting Value
Host groups (preserved)
iSCSI port settings:
● IP
● IP version
● Netmask
● Gateway
● Router (IPv6 only)
Settings:
● (preserved)
● (preserved)
● (preserved)
● (preserved)
● (preserved)
Other iSCSI settings:
● CHAP enabled
● iSNS
● Jumbo frames
Settings:
● (preserved)
● (preserved)
● (preserved)
CHAP records (preserved)
Volume identifying information (preserved)
Volume groups (preserved)
Pool settings:
● Thresholds
● Overcommit
● Limits and policy
● Snapshot space thresholds
Settings:
● (preserved)
● (preserved)
● (preserved)
● (preserved)
Volume snapshot retention priority (preserved)
Volume tier affinity (preserved)
Volume cache settings (preserved)
Expander fault isolation (preserved)
Expander PHY settings (preserved)
Device identification LED status (preserved)
Debug log settings Each parameter is reset to its default as documented for the set debug-log-
parameters on page 118 command.
Settings changed by restore defaults 439