CLI Guide

Syntax
dequarantine
disk-group disk-group
vdisk vdisk
Parameters disk-group disk-groupThe name or serial number of the disk group to remove from quarantine.
A name that includes a space must be enclosed in double quotes.vdisk vdisk
The name or serial number of the linear disk group to remove from quarantine. A name that includes a
space must be enclosed in double quotes.
Examples
After determining that linear disk group VD1 is quarantined, remove it from quarantine and re-check
its status.
# show vdisks
Name ... Status ...
-------------------
VD1 ... QTDN ... (RAID 6 quarantined with a down disk)
-------------------
# dequarantine vdisk VD1
Info: Disk group VD1 was dequarantined. (VD1)
...
# show vdisks
Name ... Status ...
-------------------
VD1 ... FTDN ... (RAID 6 fault tolerant with a down disk)
-------------------
Dequarantine disk group dgB01.
# dequarantine disk-group dgB01
See also
show disk-groups
show vdisks
trust
exit
Description
Log off and exit the CLI session.
Minimum role monitor
Syntax
exit
expand disk-group
Description
Adds disks to a disk group to expand its storage capacity.
This command applies to linear disk groups using any RAID level except NRAID and RAID 1. This
command applies to virtual disk groups using ADAPT.
The new disks must be the same type as disks already in the disk group. The disks need not have
consistent capacity;
Alphabetical list of commands 79