Install Guide
Table Of Contents
- Dell EMC SD-WAN Edge 3000 Series Installation Guide
- Disclaimer for Third Party Content
- About this guide
- Edge 3000 Series
- Site preparations
- Edge 3000 Series installation
- Platform setup
- Power supplies
- Fans
- Management ports
- User interface
- Specifications
- Dell EMC support
NOTE: Before starting this procedure, ensure that you have a terminal emulation program already installed on your personal
computer. Install the appropriate drivers to support the microUSB-B port. To download Dell EMC drivers, see https://
www.dell.com/support. If your computer requires non-Dell EMC drivers, contact Dell EMC Technical Support for assistance.
1. Power on the personal computer.
2. Connect the USB-A end of cable into an available USB port on the personal computer.
3. Connect the MicroUSB-B end of cable into the microUSB-B console port on the platform.
4. Power on the platform.
5. Install the necessary USB device drivers.
To download Dell EMC drivers, see https://www.dell.com/support. If your computer requires non-Dell EMC drivers, contact
Dell EMC Technical Support for assistance.
6. Open your terminal software emulation program to access the platform.
7. Confirm that the terminal settings on your terminal software emulation program are as follows:
● 115200 baud rate
● No parity
● 8 data bits
● 1 stop bit
● No flow control
28 Management ports