Install Guide

Parameter Specifications

Maximum operational altitude

Maximum: 10,000 feet (3,048 meters)

No performance degradation up to 3,117 feet (950 meters)

Maximum non-operational altitude 39,370 feet (12,000 meters)

Shock SV0115 — ODM

Table 5. AC power requirements

Parameter Specifications

Power supply 100–240 VAC 50/60 Hz

Typical current draw per platform

• 16 core: 110 VAC: 1.89 A

• 8 core: 110 VAC: 1.62 A

• 16 core: 240 VAC: 0.87 A

• 8 core: 240 VAC: 0.75 A

Typical power consumption

• 16 core processor with five fans: 208 W

• 8 core processor with four fans: 178 W

Maximum power consumption

• 16 core processor with five fans 312 W

• 8 core processor with four fans: 242 W

IEEE standards

The Edge 3000 Series complies with the following IEEE standards:

• 802.1ab—LLDP

• 802.1ax—Layer 2

• 802.1d, 802.1w, 802.1s, 802.1x—Mgmt/Security; 802.3x—Layer 2

• 802.3—1000BASE-KX

• 25G Etherenet Consortium 25

Agency compliance

The Edge 3000 Series complies with the following safety and agency requirements:

USA Federal Communications Commission statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.

These limits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the

instructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own

expense.

Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell EMC is not responsible for

any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or

modifications in the equipment. Unauthorized changes or modification could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired

operation.

Specifications