Owners Manual
Table Of Contents
- PowerVault NX3340 Network Attached Storage System Installation and Service Manual
- Contents
- NX3340 system product overview
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- Viewing System BIOS
- System BIOS Settings details
- System Information
- Viewing System Information
- System Information details
- Memory Settings
- Viewing Memory Settings
- Memory Settings details
- Processor Settings
- Viewing Processor Settings
- Processor Settings details
- SATA Settings
- Viewing SATA Settings
- SATA Settings details
- Boot Settings
- Viewing Boot Settings
- Boot Settings details
- Choosing system boot mode
- Changing boot order
- Integrated Devices
- Viewing Integrated Devices
- Integrated Devices details
- Serial Communication
- Viewing Serial Communication
- Serial Communication details
- System Profile Settings
- Viewing System Profile Settings
- System Profile Settings details
- System Security
- Viewing System Security
- System Security Settings details
- Creating a system and setup password
- Using your system password to secure your system
- Deleting or changing system and setup password
- Operating with setup password enabled
- Miscellaneous Settings
- Viewing Miscellaneous Settings
- Miscellaneous Settings details
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Diagnostics and indicators
- Jumpers and connectors
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Front bezel
- System cover
- Backplane cover
- Inside the system
- Air shroud
- Cooling fans
- System memory
- Processors and heat sinks
- Expansion cards and expansion card risers
- Network daughter card
- Integrated storage controller card
- Hard drives
- Drive backplane
- System battery
- USB module
- Optional internal USB memory key
- Optical drive—optional
- Power supply units
- System board
- Trusted Platform Module
- Control panel
- Getting help
System Xa Xb Y Za (with
bezel)
Za
(without
bezel)
Zb
*
Zc
8 x 2.5 inch 482.0 mm
(18.97
inches)
434.0 mm
(17.08
inches)
42.8 mm
(1.68
inches)
35.84 mm
(1.41 inches)
22.0 mm
(0.87
inches)
683.05 mm
(26.89 inches)
721.91
(28.42
inches)
NOTE:
*
indicates that Zb goes to the nominal rear wall external surface, where the system board I/O connectors are
located.
Chassis weight
The maximum chassis weight is 21.9 kg (48.28 lbs).
Processor specifications
The NX3340 system supports up to two Intel Xeon Processor Scalable Family processors.
PSU specifications
The NX3340 system supports up to two AC power supply units (PSUs).
Table 1. PSU specifications
PSU Class Heat dissipation
(maximum)
Frequency Voltage
750 W AC Platinum 2891 BTU/hr 50/60 Hz 100–240 V AC, autoranging
NOTE: Heat dissipation is calculated using the PSU wattage rating.
NOTE: This system is also designed to connect to the IT power systems with a phase to phase voltage not exceeding 230
V.
System battery specifications
The NX3340 system contains a CR 2032 3.0-V lithium coin cell system battery.
Technical specifications
15