Owners Manual

2. Push both blue retention clips simultaneously and lift the processor and heat sink module (PHM) out of the system.
3. Set the PHM aside with the processor side facing up.
Figure 31. Removing a processor and heat sink module
Next steps
Install the Processor and heat sink module.
Removing the processor from the processor and heat sink module
Prerequisites
NOTE:
Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink.
This procedure is not required when replacing a system board.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the air shroud.
4. Remove the processor and heat sink module.
Steps
1. Place the heat sink with the processor side facing up.
2. Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break
the thermal paste seal.
3. Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
72
Installing and removing system components