Owners Manual

Steps
1. If removed, install the expansion cards into the expansion card riser.
2. Hold the touch points, and align the expansion card riser with the connector and the riser guide pin on the system board.
3. Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
Figure 40. Installing the expansion riser 1A
Figure 41. Installing the expansion riser 2A
Next steps
1. Follow the procedures in After working inside your system.
2. Install any device drivers required for the card as described in the documentation for the card.
Removing an expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
Installing and removing system components
81