Owners Manual

System health and system ID indicator codes
The system health and system ID indicator is located on the left control panel of your system.
Figure 12. System health and system ID indicators
System health and system ID
indicator code
Condition
Solid blue Indicates that the system is turned on, system is healthy, and system ID mode is not
active. Press the system health and system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system health and system ID
button to switch to system health mode.
Solid amber Indicates that the system is in fail-safe mode. If the problem persists, see the Getting
help section.
Blinking amber Indicates that the system is experiencing a fault. Check the System Event Log or the
LCD panel, if available on the bezel, for specific error messages. For information
about the event and error messages generated by the system firmware and agents
that monitor system components, go to qrl.dell.com > Look Up>Error Code, type
the error code, and then click Look it up.
NIC indicator codes
Indicators on each NIC provide information about the activity and link status. The activity LED indicator indicates if data is
flowing through the NIC, and the link LED indicator indicates the speed of the connected network.
Figure 13. NIC indicator codes
1. link LED indicator
2. activity LED indicator
Status
Condition
Link and activity indicators are off The NIC is not connected to the network.
Link indicator is green and activity indicator is blinking
green
The NIC is connected to a valid network at its maximum port speed
and data is being sent or received.
Diagnostics and indicators 47