Owners Manual

Figure 21. Removing the expansion card riser assembly

Next step

Install the expansion card riser assembly.

Installing the expansion card riser assembly

Prerequisite

NOTE

: You must install an expansion card ller bracket over an empty expansion slot to maintain Federal Communications

Commission (FCC) certication of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling

and airow inside the system.

Follow the safety guidelines listed in Safety instructions.

Steps

1 Place the expansion card assembly into the system board assembly.

2 Align the riser card connector with the connector on the system board, and press the expansion card riser assembly into place.

3 Using the Phillips #2 screwdriver, tighten the screws that secure the expansion card riser assembly.

Installing and removing system components