Reference Guide

Technical support and resources
10 Dell EMC XC Series Appliance and XC Core System Remote Direct Memory Access Deployment Guide
Solution: Make sure you have 2 CX4 Adapter on the supported hardware. Refer to the section for hardware
requirements.
1. Check ip a |grep rdma0 to make sure that interface rdma0 is created.
2. Make sure IPs match from the RDMA interfaces; allssh ip a |grep rdma0 (check that the creation
was successful and the interfaces were brought up).
3. Refer to /home/nutanix/data/logs/genesis.out for any failure.
4. For any reason RDMA is disabled, make sure it is enabled. See configuration steps on enabling interface.
For the RDMA architecture overview, refer to the Nutanix website.
https://portal.nutanix.com/
NOTE: Use Nutanix credentials to log in and then search for RDMA.
For information on Configuring Network Segmentation on an Existing RDMA Cluster, refer to the Nutanix KB
article located here
.