Service Manual

Steps
1. Angle the mini PERC card to engage with the mini PERC card holder on the system board.
2. Lower the mini PERC card into place until the mini PERC card is firmly seated on the card holder.
Figure 74. Installing the mini PERC card
3. Align the screws on the cable with the screw holes on the mini PERC card.
4. Using a Phillips #2 screwdriver, secure the cable to the mini PERC card with the screws.
Figure 75. Installing the mini PERC card cable
Next steps
1. If removed, Install the expansion card risers.
2. Install the air shroud.
3. Follow the procedure listed in the After you work inside your system.
104
Installing and removing system components