Service Manual

Table 63. Dell EMCXC Core XC6515 system USB specifications (continued)
Front Rear Internal
USB port type No. of ports USB port type No. of ports USB port type No. of ports
Micro USB 2.0-
compliant port for
iDRAC Direct
One
NOTE: The micro USB 2.0 compliant port can only be used as an iDRAC Direct or a management port.
LOM riser card specifications
The XC Core XC6515 system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports that are located
on the back panel. The system also supports LAN on Motherboard (LOM) on an optional riser card.
You can install one LOM riser card. The supported LOM riser options are:
● 2 x 10Gb Base-T
● 2 x 10Gb SFP+
● 2 x 25Gb SFP+
NOTE:
● You can install up to two PCIe add-on NIC cards.
● For information about Linux network performance settings, see the Linux Network Tuning Guide for AMD EPYC
Processor Based Servers white paper at AMD.com
Serial connector specifications
The Dell EMCXC Core XC6515 system supports one serial connector on the back panel, which is a 9-pin connector, Data
Terminal Equipment (DTE), 16550-compliant.
VGA ports specifications
The XC Core XC6515 system supports two 15-pin VGA ports one each on the front and back panels.
IDSDM
The XC Core XC6515 system supports Internal Dual SD module (IDSDM) with the below storage capacity:
● 32 GB
● 64 GB
NOTE: One IDSDM card slot is dedicated for redundancy.
NOTE: Use Dell EMC branded microSD cards that are associated with the IDSDM configured systems.
Video specifications
The Dell EMCXC Core XC6515 system supports integrated Matrox G200eR2 graphics controller with 16 MB of video frame
buffer.
132
Technical specifications