Service Manual

You need the following tools to assemble the cables for a DC power supply unit:

● AMP 90871-1 hand-crimping tool or equivalent

● Tyco Electronics 58433-3 or equivalent

● Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire

NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).

Optional front bezel

NOTE: LCD panel is optional on the front bezel. If the front bezel has an LCD panel, see LCD panel section.

Remove the front bezel

The procedure to remove the front bezel with and without the LCD panel is the same.

Prerequisites

● Follow the safety guidelines listed in the Safety instructions.

● Keep the bezel key handy.

The bezel key is part of the LCD bezel package.

Steps

1. Unlock the bezel.

2. Press the release button, and disengage the left end of the bezel.

3. Unhook the right end, and remove the bezel.

Figure 14. Removing the front bezel with the LCD panel

Next steps

Install the front bezel.

Installing and removing system components