Service Manual

Figure 16. Removing the system cover

Next steps

Install the system cover.

Install the system cover

This section describes how to install the system cover.

Prerequisites

● Follow the safety guidelines listed in the Safety instructions.

● Follow the procedure listed in Before you work inside your system.

● Ensure that all internal cables are connected and routed properly, and no tools or extra parts are left inside the system.

Steps

1. Align the tabs on the system cover with the guide slots on the system.

2. Close the system cover release latch.

3. Using a 0.635 cm (0.25 inches) flat head or Phillips #2 screwdriver, rotate the lock clockwise to the lock position.

Installing and removing system components