Service Manual

3. Press the release tabs on the fan cable connector and connect the cable to the system board.
Figure 23. Installing a cooling fan
Next steps
1. Install the air shroud.
2. Follow the procedure listed in After you work inside your system.
Intrusion switch
Remove the intrusion switch
Prerequisites
● Follow the safety guidelines listed in the Safety instructions.
● Follow the procedure listed in the Before working inside your system.
● Remove the air shroud.
● Keep the plastic scribe ready.
Steps
1. Disconnect and remove the intrusion switch cable from the connector on the system board.
Observe the routing of the cable as you remove it from the system.
2. Using a plastic scribe, slide the intrusion switch out of the intrusion switch slot.
Installing and removing system components
61