Service Manual

Install the expansion card risers
Prerequisites
● Follow the safety guidelines listed in the Safety instructions.
● Follow the procedure listed in the Before working inside your system.
● If removed, install the expansion cards into the expansion card risers.
Steps
1. Holding the touch points, align the expansion card riser with the connector and the riser guide pin on the system board.
2. Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 50. Installing the low profile left riser
NOTE: For low profile riser right, tighten the captive screw to secure the riser to the system board.
Installing and removing system components 87