Service Manual

MicroSD card
Remove the MicsoSD card
Prerequisites
● Follow the safety guidelines listed in the Safety instructions.
● Follow the procedure listed in the Before you work inside your system.
● Remove the air shroud.
● Remove the ISDM module.
Steps
1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. For more
information on the slot location, see System board jumpers and connectors section.
2. Hold the MicroSD card and remove it from the slot..
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
Figure 60. Removing the MicroSD card
Next steps
Install the MicroSD card.
Install the MicroSD card
Prerequisites
● Follow the safety guidelines listed in the Safety instructions.
● Follow the procedure listed in Before working inside your system.
● Remove the air shroud.
NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: Ensure that you install the MicroSD cards into the same slots that are based on the labels you had marked on the
cards during removal.
Installing and removing system components 93