Service Manual

Figure 63. Installing the M.2 SSD module

Next steps

1. Install the BOSS card.

NOTE: The procedure to install the BOSS card is similar to removing an expansion card.

2. Install the air shroud.

3. Follow the procedure listed in the After you work inside your system.

IDSDM module

Remove the IDSDM module

Prerequisites

● Follow the safety guidelines listed in the Safety instructions.

● Follow the procedure listed in the Before you work inside your system.

● Remove the air shroud.

● If you are replacing the IDSDM card, remove the MicroSD cards.

NOTE:

Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into

the corresponding slots.

Steps

Holding the pull tab, lift the IDSDM card out of the system.

Installing and removing system components