Service Manual

Figure 65. Installing the IDSDM module
Next steps
1. Install the MicroSD card.
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2. Install the air shroud.
3. Follow the procedure listed in the After you work inside your system.
LOM riser card
Remove the LOM riser card
Prerequisites
● Follow the safety guidelines listed in the Safety instructions.
● Follow the procedure listed in the Before you work inside your system.
● Remove the air shroud.
● If installed, remove the risers.
Steps
1. Using a Phillips #2 screwdriver, remove the screws that secure the LAN on Motherboard (LOM) riser card to the system
board.
2. Push apart the two blue plastic clips securing the LOM riser card to release the riser.
3. Holding the LOM riser card by the edges, lift to disconnect the card from the connector on the system board.
4. Slide the LOM riser card towards the front of the system until the Ethernet connectors or the SFP+ are clear of the slot in
the back panel.
98
Installing and removing system components