Owners Manual

Next steps
1. Install the air shroud.
2. If removed, install expansion cards into the riser.
3. If applicable, open the PCIe card holder latch on the air shroud to install the full length card.
4. Follow the procedure listed in After working inside your system on page 57.
5. Install any device drivers required for the card as described in the documentation for the card.
Removing an expansion card riser 3
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 56.
2. Follow the procedure listed in Before working inside your system on page 57.
3. Remove the air shroud.
NOTE: If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
4. If installed, expansion cards from the riser.
5. Disconnect any cables connected to the riser card.
Steps
To remove expansion card riser 3:
a. loosen the screws that secure the riser to the system by using Phillips #2 screwdriver.
b. Press the release tab, holding the riser by its edges, and then lift the riser from the riser connector on the system board.
Figure 57. Removing the expansion riser 3
Next steps
Install the expansion card riser 3.
Installing an expansion card riser 3
Prerequisites
Follow the safety guidelines listed in Safety instructions.
100
Installing and removing system components