Owners Manual

Figure 60. Installing IDSDM card
Next steps
1. Install the micro SD cards.
NOTE:
Re-install the micro SD cards into the same slots based on the labels you had marked on the cards during
removal.
2. If applicable, install the rear hard drive cage.
3. If applicable, install the full height PCIe card.
4. Follow the procedure listed in After working inside your system on page 57.
Network daughter card
The network daughter card (NDC) is a small, removable mezzanine card, which provides the flexibility of selecting different
network connectivity options.
Removing the network daughter card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 56.
2. Follow the procedure listed in Before working inside your system on page 57.
3. Remove the expansion card riser 2.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system
board.
2. Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3. Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
104
Installing and removing system components