Users Guide
Table Of Contents
- Lifecycle Controller User's Guide
- Contents
- Introduction
- Using Lifecycle Controller
- Operating system deployment
- Monitor
- Hardware inventory view and export
- About view and export current inventory
- About view and export factory-shipped inventory
- Viewing hardware inventory — current or factory shipped
- Exporting hardware inventory — current or factory shipped
- Viewing or exporting hardware inventory after part replacement
- Viewing or exporting current inventory after resetting Lifecycle Controller
- Lifecycle Controller log
- Firmware update
- Configure
- System control panel access options
- Configuring iDRAC
- Configuring system time and date
- Configuring RAID
- Configuring RAID using software RAID
- Creating a secure virtual disk on a RAID controller
- Key encryption
- Local key encryption mode
- Breaking mirrored drives
- System setup — Advanced Hardware Configuration
- Collect system inventory on restart
- Configuring a local USB drive
- Configuring NFS and CIFS servers
- Conditions while configuring HTTP or HTTPS server
- Maintain
- Easy-to-use system component names
- Using the system setup and boot manager
- Troubleshooting and frequently asked questions
Table 6. Recommended characters while accessing network shares
Characters Length
0-9
A-Z
a-z
- * / : ? @ \ _ |
User name: 1-16
Password: 1-20
Viewing summary of network settings
This page provides a summary of the Lifecycle Controller and iDRAC IP configurations. Verify the configurations and click Finish
to save the settings and exit from the Settings wizard.
Accessing help
Each Lifecycle Controller page has a help associated with it. Press <F1> or click Help (in the upper-right corner) to view the
help information about the features available on a page.
Viewing release notes
1. To view the release notes, click About on any page of Lifecycle Controller.
NOTE: The About option is not available from the help pages.
2. Click View Release Notes.
Setting up Lifecycle Controller from the home page
If you miss to make any changes in the Initial Setup Wizard, or if you want to make any configuration changes later, restart
the server, press F10 to launch Lifecycle Controller, and select Settings from the home page.
Specifying language and keyboard type
1. Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.
2. On the left pane, click Settings.
3. On the Settings pane, click Language and Keyboard. Use the up-and down-arrow keys to select options.
● From the Language drop-down menu, select the language.
● From the Keyboard Type drop-down menu, select the keyboard type.
4. Click Next to save the new settings.
Configuring Lifecycle Controller Network Settings
Use this page to configure network settings for a NIC.
1. Start Lifecycle Controller. For more information, seeStarting Lifecycle Controller.
2. On the left pane, click Settings.
3. On the Settings pane, click Network Settings.
4. From the NIC Card drop-down menu, select the NIC port that you want to configure.
NOTE: You can use only one NIC at a time to communicate with the network.
5. From the IPV4 Network Settings→ IP Address Source drop-down menu, select one of the following options:
● DHCP — indicates that the NIC must be configured by using an IP address from a DHCP server. DHCP is the default
option and the DHCP IP address is displayed on the Network Settings page.
Using Lifecycle Controller
15