CLI Guide
Introduction
This document provides information about the RACADM subcommands, supported RACADM interfaces, and property database
groups and object definitions for iDRAC for the Dell EMC servers.
Topics:
• New features added
• Deprecated and New Subcommands
• Unsupported RACADM Subcommands
• Supported RACADM Interfaces
• RACADM Syntax Usage
• Proxy parameters
• Supported PowerEdge RAID Controller cards
• Other Documents You May Need
• Accessing documents from Dell support site
• Contacting Dell
New features added
This section provides the list of new features added in the following releases:
● Firmware version 4.40.00.00 on page 12
● Firmware version 4.32.10.00 on page 12
● Firmware version 4.30.30.30 on page 13
● Firmware version 4.20.20.20 on page 13
● Firmware version 4.10.10.10 on page 13
● Firmware version 4.00.00.00 on page 13
Firmware version 4.40.00.00
Following features were added or updated in this release:
● Removed systemconfig command and its features
● Removed support for telnet
● Removed support for INI file system from get and set commands
● Removed support for TLS 1.0
● Removed support for config and getconfig commands
● Added support for PPIN property in CPU output of hwinventory command
● Added support for RollupStatus property in getsysinfo command
● Added support for --includeCustomTelemetry input in get command
● Added support for --customdefaults input inget and set commands
● Added support for --savecustomdefaults input in set command
● Added support for Custom certificate input
● Added support for RSA CA certificate input
Firmware version 4.32.10.00
Following features were added in this release:
● Added support for SCV signed certificate download
1
12 Introduction