CLI Guide

Table 99. Details of sslkeyupload (continued)
○ 1 — SSL key used to generate the server certificate.
● -f — Specifies the filename of the SSL key that must be uploaded.
Output If upload is successful, the message SSL key successfully uploaded to the RAC is displayed. if
upload is unsuccessful, error message is displayed.
Example
racadm sslkeyupload -t 1 -f c:\sslkey.txt
sslresetcfg
Table 100. Details sslresetcfg
Description Restores the web-server certificate to factory default and restarts web-server. The certificate takes effect
30 seconds after the command is entered.
To run this subcommand, you must have the Configure iDRAC privilege.
Synopsis
racadm sslresetcfg
Input N/A
Example
racadm sslresetcfg
Certificate generated successfully and webserver restarted.
storage
Table 101. Details of storage
Description Allows you to run the commands to control storage arrays.
To run this subcommand for configuring the storage properties, you must have the server control
permission.
Synopsis
Inventory
NOTE: You can also run the command using raid in place of the storage command.
● To view the help details for get command, run the following command:
racadm storage help get
● To generate and view information about the inventory of storage root node, run the following
command:
racadm storage get status
● To generate and view information about the inventory of controllers, run the following command:
racadm storage get controllers -o
racadm storage get controllers -o -p <property names separated by comma>
● To get the list of controllers, run the following command:
racadm storage get controllers
124 RACADM Subcommand Details