CLI Guide

Firmware version 4.30.30.30
Following features were added in this release:
● Added support for PCIe Gen 4 NVMe drives with PERC 11
● Added support for infinibandstatistics command
● Added support for sd option for virtual disk encryption
● Added support for additional controller properties such as - AutoConfigBehavior, in racadm storage get
<controller> output
● Added support for additional physical disk properties such as - Certified, NonRAIDDiskCachePolicy and,
EncryptionProtocol in racadm storage get <pdisk> output
● Added support for stacking controller local key management (LKM) setting and creating secure virtual disk using one target
config job
● Added support for BOSS-S2 controllers. These controllers also support LED blink and unblink along with hot plugging M.2
drives
Firmware version 4.20.20.20
Following features were added in this release:
● Added support for inventory of PCIe Gen 4 NVMe drives with data transfer speeds up to 16 GTs
● Added support for secure erase and prepare to remove features for PCIe SSDs
● Added support for OEM power supply units
Firmware version 4.10.10.10
Following features were added in this release:
● Added support for biosscan command
● Added support for infiniband systems management
● Added PCI Express Generation property in the get command output of storage enclosure device
Firmware version 4.00.00.00
Following features were added in this release:
● The default prompt from SSH to iDRAC is now racadm>>
● Added support for httpsbootcert command
● Added support for networktransceiverstatistics command
● Added support for testrsyslogconnection command
● Added support for serialcapture command
● Added support for Dell EMC OpenManage Secure Enterprise Key Manager with the new SEKM subcommand
● Added support for remote / programmatic support for HTTPS Cert Management
● Added support for SFP transceiver inventory via iDRAC
● Added support for enhanced commands to support HTTP/HTTPS/FTP/TFTP share types
● Added support for enhanced GPU management
● Added support for streaming telemetry data from iDRAC
● Added support for retrieving telemetry data from SupportAssist
● cd.. command changed to cd ..
● Added racadm error codes
Deprecated and New Subcommands
NOTE:
● Following commands are deprecated, and will not be available from iDRAC version 4.40.00.00 and onwards. You must
reconfigure the scripts that use these commands to avoid any issues or failures.
Introduction 13