CLI Guide

Table 101. Details of storage (continued)

● To rename, expansion and raid level migration of the virtual disks and, to rebuild, cancel rebuild and

cancel the back-ground initialization, run the following command:

racadm storage renamevd:<VD FQDD > -name <new_vd_name>

racadm storage capacityexpansion:<VD FQDD > -size <new size VD> -pdkey

racadm storage capacityexpansion:<VD FQDD> -size <new size>.

racadm storage discardcache:<Controller FQDD>

racadm storage raidlevelmigration:<VD FQDD > -new_rl <raid_level> -

pdkey:<PD FQDD separated by commas>

racadm storage rebuild:<PD FQDD>

racadm storage cancelrebuild:<PD FQDD>

racadm storage cancelbgi:<VD FQDD>

● To convert the physical disk drives and assign or delete a hotspare. To scan physical disks that are

connected to a controller and detect problem, run the following command:

racadm storage converttononraid:<PD FQDD>

racadm storage converttoraid:<PD FQDD>

-mdtype <metadataType>

NOTE:

Convert to RAID or Non RAID is not supported on PERC 10 (RAID mode) and BOSS

controller cards. PERC10 in eHBA mode supports convert to RAID or Non-RAID.

NOTE: -mdtype is only supported for SWRAID controllers.

racadm storage hotspare:<PD FQDD> -assign yes -type dhs -vdkey: <VD

FQDD>

racadm storage hotspare:<PD FQDD> -assign yes –type ghs

racadm storage hotspare:<PD FQDD> -assign no

racadm storage patrolread:<Controller FQDD> -state start|stop

NOTE:

If the –assign option is no, you cannot add other options. If the –assign option is yes

and if the -type option is not present, the global hotspare (ghs) is created by default.

● To reset, clear, and import the storage configuration to the controller, run the following command:

racadm storage importconfig:<Controller FQDD>

racadm storage resetconfig:<Controller FQDD>

racadm storage clearconfig:<Controller FQDD>

130

RACADM Subcommand Details