CLI Guide

ManualsBrandsDell ManualsAX NodesEMC XC Core XCXR2

vflashpartition

vmdisconnect

quit

● Example 2: racadm>> get <press tab>

get

getconfig

getled

getniccfg

getraclog

getractime

getsel

getsensorinfo

getssninfo

getsvctag

getsysinfo

gettracelog

getversion

● Example 3:

racadm>> getl<press tab>

racadm>> getled <press enter> or <racadm getled>

LEDState: Not-Blinking

● Example 4:

racadm>> get bios.uefiBootSettings

BIOS.UefiBootSettings

BIOS.UefiBootSettings.UefiBootSeq

BIOS.UefiBootSettings.UefiPxeIpVersion

NOTE:

● In the RACADM autocomplete mode, type the commands directly without giving racadm as prefix.

● NIC/FC/InfiniBand FQDDs are configuration-dependent. To find FQDDs present in system, run the RACADM command

racadm hwinventory NIC/FC/InfiniBand

Lifecycle Controller Log

Lifecycle Controller logs provide the history of changes related to components installed on a managed system. You can also add

work notes to each log entry.

The following events and activities are logged:

● System events

● Storage devices

● Network devices

● Configuration

● Audit

● Updates

You can view and filter logs based on the category and severity level. You can also export and add a work note to a log event.

If you initiate configuration jobs using RACADM CLI or iDRAC web interface, the Lifecycle log captures the information about

the user, interface used, and the IP address of the system from which you initiate the job.

Proxy parameters

Some commands do not support setting the proxy parameters if the share location (-l) is HTTP/HTTPS. To perform the

operation with HTTP or HTTPS through a proxy, the proxy parameters must be first configured using the

lifecyclecontroller.lcattributes. Once these proxy parameters are configured, they become the part of default configuration; the

proxy attributes should be cleared to end use of the HTTP/HTTPS proxy.

Introduction