CLI Guide

cfgIPv6LanNetworking
This group is used to configure the IPv6 over LAN networking capabilities.
Use this object with the config or getconfig subcommands.
The following sections provide information about the objects in the cfgIPv6LanNetworking group.
cfgIPv6Enable (Read or Write)
Table 309. Details of cfgIPv6Enable
Description
Enables or disables iDRAC IPv6 stack.
Legal Values
● 1 (TRUE)
● 0 (FALSE)
Default
0
cfgIPv6Address1 (Read or Write)
Table 310. Details of cfgIPv6Address1
Description
Specifies iDRAC IPv6 address.
Legal Values
String representing a valid IPv6 entry.
Default
:
cfgIPv6Gateway (Read or Write)
Table 311. Details of cfgIPv6Gateway
Description
iDRAC gateway IPv6 address.
Legal Values
Specifies string representing a valid IPv6 entry.
Default
“ :: “
cfgIPv6AutoConfig (Read or Write)
Table 312. Details of cfgIPv6AutoConfig
Description
Enables or disables the IPv6 Auto Configuration option.
NOTE: If this value is set to 0, the iDRAC disables auto configuration and statically assigns IPv6
addresses. If this value is set to 1, the iDRAC obtains address and route information using stateless
auto configuration and DHCPv6.
NOTE: The iDRAC uses its MAC address for its DUID (DUID-LL) when communicating with a DHCPv6
server.
Legal Values
● 1 (TRUE)
● 0 (FALSE)
Default
0
iDRAC Property Database Group and Object Descriptions 215