CLI Guide

cfgNetTuningNic100MB (Read or Write)
Table 354. Details of cfgNetTuningNic100MB
Description
Specifies the speed for iDRAC NIC.
NOTE: To set this property:
● iDRAC NIC selection must be set to Dedicated mode.
● iDRAC NIC Auto negotiation must be disabled.
● iDRAC IPv4 must be enabled.
● iDRAC IPv4 DHCP must be enabled.
● iDRAC IPv6 must be enabled.
● iDRAC IPv6 auto configuration must be enabled.
Legal Values
● 0 (10 MBit)
● 1 (100 MBit)
● 2 (1000 MBit)
NOTE: You cannot manually set the Network Speed to 1000 MBit. This option is available only if
cfgNetTuningNicAutoNeg is set to 1 (Enabled).
Default
1
cfgNetTuningNicFullDuplex (Read or Write)
Table 355. Details of cfgNetTuningNicFullDuplex
Description
Specifies the duplex setting for the NIC.
Legal Values
● 0 (Half Duplex)
● 1 (Full Duplex)
Default
1
Dependency
None
cfgNetTuningNicMtu (Read or Write)
Table 356. Details of cfgNetTuningNicMtu
Description
Indicated the maximum size of units in bytes transmitted by NIC.
Legal Values
576–1500
Default
1500
cfgSensorRedundancy
This group is used to set the power supply redundancy.
The following sections provide information about the objects in the cfgSensorRedundancy group.
This group is applicable only for iDRAC on Rack and Tower Servers and not for iDRAC Enterprise on Blade Servers.
226
iDRAC Property Database Group and Object Descriptions