CLI Guide

Table 16. Details of closessn (continued)
Synopsis
● racadm closessn –i <session_ID>
●
racadm closessn -a
● racadm closessn -u <username>
Input
● —i <session_ID> — The session ID of the session to close, which can be retrieved using RACADM
getssninfo subcommand.
Session running this command cannot be closed.
● —a — Closes all sessions.
● —u <username> — Closes all sessions for a particular user name.
Output
Successful or error message is displayed.
Example
● Closes the session 1234.
racadm closessn -i 1234
● Closes all the sessions other then the active session for root user.
racadm closessn –u root
● Closes all the sessions.
racadm closessn –a
clrsel
Table 17. Details of clrsel
Description
Removes all the existing records from the System Event Log (SEL).
To use this subcommand, you must have Clear Logs permission.
Synopsis
racadm clrsel
Example
● racadm clrsel
The SEL was cleared successfully
connect
Table 18. Details of connect
Description
Allows you to connect to the switch or blade serial console.
NOTE: This subcommand is only supported on the firmware interface.
Synopsis
● racadm connect [-b] -m <module>
Input
● -b—binary mode.
NOTE: If -b is used, CMC must be reset to terminate connect.
● -m—module, and can be one of the following values:
40 RACADM Subcommand Details